Unmanned systems / 2025–26
5 foot modular UAV
A 5 foot drone I designed to carry different payloads and test onboard compute and sensors.
Prototype · Still making changes
I started working on RC planes and other unmanned projects in middle school. I wanted more room to add my own electronics and sensors than most commercial drones offered, so I started designing this 5 foot UAV. I wanted it to carry different payloads and let me test new hardware without having to redesign the whole drone, while keeping the cost down. The current design has an expected payload capacity of about 20 lbs.
The frame has two 50×50 mm mounts that also fit 30×30 mm and 20×20 mm mounting patterns, plus four 1×1 inch side mounts. I included three power rails: 22.2V for the motors, 12V for the Jetson, VTX, and sensors that need more power, and 5V for most logic and lower power sensors. There is also an isolated 3.3V supply for GPIO.
For V4, I switched to pancake motors with 22 inch props, which should provide more thrust and better efficiency.
The design has changed a lot from the first concept to the current prototype.
Pictures and CAD
21 original images · Select any image to enlarge
V4 — Current design
V4 · View full image ↗
V4 · View full image ↗
V4 · View full image ↗
V4 · View full image ↗
V4 · View full image ↗
V4 · View full image ↗
V4 · View full image ↗V3 — Taller motors
V3 · View full image ↗
V3 · View full image ↗
V3 · View full image ↗
V3 · View full image ↗
V3 · View full image ↗
V3 · View full image ↗
V3 · View full image ↗V2 CAD
V2 CAD · View full image ↗
V2 CAD · View full image ↗
V2 CAD · View full image ↗
V2 CAD · View full image ↗
V2 CAD · View full image ↗
